Selecta UV 3100 Manual De Instrucciones página 44

INSTRUCTION MANUAL CODE 80260 REV A
Fig. 4.8
Fig. 4.9
Fig. 4.10
J
.P. SELECTA s.a.u.
Feb/2017
•
Step 6, Measure Samples:
Place the sample to be tested in the light path, press [START/STOP] to measure.
Then the test result will be displayed in the data sheet. Repeat this step to finish
measuring all the samples (Fig. 4.8).
•
Step 7, Print Data:
Press [PRINT] to print the result.
•
Step 8, Delete Data:
Press &
press [CLEAR] to delete the value.
•
Step 9, Store the Data:
After measurement, press [SAVE] to store the data. Input the file name by the
numeric keypad and then press [ENTER] to store.
5.3.3 Wavelength Scan
•
Step 1, Go into Wavelength Scan Screen:
In the main menu, press the numeric key [3] or
Scan» and press [ENTER] to enter (Fig. 4.9).
•
Step 2, Parameters Setup:
Press F1 to set parameters, set «Scan From», «scan to», «scan step» and «scan
speed», press [ENTER] to confirm.
•
Step 3, Set Photometric Mode:
Press F2 to set photometric mode, choose «T%», «Abs.» or «E» and press [ENTER]
to confirm.
•
Step 4, Scan Baseline:
Place the Reference Sample in the light path, press [100%T/0 ABS] to scan the
baseline, and press [ESC] to cancel.
•
Step 5, Scan Samples:
Put the samples in the light path, press [START/STOP] to scan the sample (Fig.
4.10), press [ESC] to cancel.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.jpselecta.es
(It can be modified without notice)
to move the cursor of «*» to the value you don't need, then
Tel 34 93 770 08 77 Fax 34 93 770 23 62
Page: 44
& to choose «Wavelength