Troubleshooting - Scheppach HS100S Traducción De Las Instrucciones Originales De Funcionamiento

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.

16. Troubleshooting

Problem Possible cause
Saw blade gets loose Fixing nut not tight enough
after turning off the
motor
Motor does not start Mains fuse blown
Extension cable defect
Connections to the motor or switch
not OK
Motor or switch defective
Motor not supplying Cross section of the extension cable
power, fuse tripping insufficient
Overload due to blunt saw blade
Burn areas at the Blunt saw blade
cutting surface
Wrong saw blade
36 | GB
 www.scheppach.com /  [email protected] /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Help
Tighten fixing nut with right-hand thread
Check the mains fuse
Replace the extension cable
Have it checked by an electrician
Have it checked by an electrician
See "Electrical Connection" in the operating manual
Replace saw blade
Sharpen saw blade, replace
Replace saw blade