BATTERY REPLACEMENT
NOTE: Do not mix old and new ba eries. Do not
mix alkaline, standard or rechargeable ba eries.
is safe uses 4 - AA ba eries. Under normal use,
ba eries will last about 1 year.
NOTE: If the ba eries are low, the yellow light will
ash when you start to enter your code.
To replace the ba eries, open the ba ery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
ba eries.
TURNING THE KEYPAD SOUND
OFF/ON
Your safe comes with the "Beep" sound turned on.
You can turn o the "Beep" sound of the keypad
by pressing the
... key.
To turn the "Beep" sound on, press the
key again.
SELECTING A LOCATION
is safe must be mounted into a drawer. For
optimal safety and security, the safe should be
installed in an isolated, dry and secure area.
SECURING THE SAFE
NOTE:
Failure to do so will compromise the safety and
security of the safe.
Select an appropriate sized drawer for your safe. Place
the safe in the drawer and try opening and closing the
safe and drawer. Do not a empt to close the drawer
with the safe open.
Place the safe in the desired drawer and mark the
mounting holes with a pencil. Remove the safe and
drill the pilot holes for the screws. Replace the safe in
the drawer and insert the screws through the mounting
holes and drawer bo om. Secure the bolt by tightening
....
the Nylock nut on the screws. (Figure 1)
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
is safe must be mounted into a drawer.
Figure 1
3
12
40659-1512