Battery Replacement; Selecting A Location - STACK-ON PDS-1500 Instrucciones

BATTERY REPLACEMENT

NOTE: Do not mix old and new ba eries. Do not
mix alkaline, standard or rechargeable ba eries.
is safe uses 4 - AA ba eries. Under normal use,
ba eries will last about 1 year.
NOTE: If the ba eries are low, the yellow light will
ash when you start to enter your code.
To replace the ba eries, open the ba ery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
ba eries.
TURNING THE KEYPAD SOUND
OFF/ON
Your safe comes with the "Beep" sound turned on.
You can turn o the "Beep" sound of the keypad
by pressing the ... key.
To turn the "Beep" sound on, press the
key again.

SELECTING A LOCATION

is safe must be mounted into a drawer
(PDS-1500) or into a drawer or the wall
(PDS-1505). For optimal safety and security, the
safe should be installed in an isolated, dry and
secure area.
SECURING THE SAFE
NOTE:
(PDS-1500) or into a drawer or the wall
(PDS-1505). Failure to do so will compromise
the safety and security of the safe.
DRAWER MOUNTING
Select an appropriate sized drawer for your safe.
Place the safe in the drawer and try opening and
closing the safe and drawer. Do not a empt to
close the drawer with the safe open.
Place the safe in the desired drawer and mark the
mounting holes with a pencil. Remove the safe and
drill the pilot holes for the screws. Replace the safe
....
in the drawer and insert the screws through the
mounting holes and drawer bo om. For maximum
security, use 2 mounting screws. Secure the screw
by tightening the Nylock nut on the screws.
(Figure 1)
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
is safe must be mounted into a drawer
Figure 1
3
18
40536-1506