LOCKING THE SAFE
To lock the safe, close the door and turn the knob to
the le to the 12:00 position.
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds a er the ngerprint
is entered, wait a minimum of 6 seconds from the
time the combination is entered to lock the safe.
Also, when locking the safe, always make sure the
knob is turned completely to the le to the 12:00
position. If the knob is not turned to the 12:00
position during the locking process, the locking
mechanism will not lock.
BATTERY REPLACEMENT
NOTE: Do not mix old and new ba eries. Do not
mix alkaline, standard or rechargeable ba eries.
is safe uses 4 - AA ba eries. Under normal use,
ba eries will last about 1 year.
NOTE: If the ba eries are low, the yellow light
will ash when you press the scanner.
To replace the ba eries, open the ba ery
compartment on the back of the door by pushing
the tab in the direction of the arrow and install all
new ba eries.
CLEARING THE MEMORY
To clear the memory of all recorded ngerprints,
locate the reset bu on on the inside of the safe
and press this bu on for about 5 seconds until
the green light ashes 10 times with 10 beeps (if
the sound is turned on). All recorded scans will
be erased.
NOTE: For security you must record a
ngerprint. Failure to do so will compromise
the safety and security of the safe.
3
18
40540-1507