Battery Installation - STACK-ON SHD-SU-BG-E Manual De Instrucciones

BATTERY INSTALLATION

You must first install the battery which is
located in the front protective styrofoam.
NOTE: When changing the battery, always hold
the battery connecting cap while disconnecting
or attaching the battery. Do not pull on the
wires. Doing this could cause the power supply
to become disconnected from the lock.
This safe uses one 9V alkaline battery. Under
normal use, batteries will last about 1 year.
When the battery is low and you press a button
on the keypad, a red light will come on warning
you that the battery is low.
To replace the battery, remove the cover by
pressing the tab and turning the cover as shown
in the illustration. Replace the old battery and
screw the cover back in place.
TAB
ELECTRONIC LOCK
After installing the battery, to open the electronic
lock the first time, press the following
numbers/symbols on the electronic keypad in this
order: 1 - 5 - 9 - #. These numbers are preset.
NOTE: You should change the entry code as
soon as possible after opening the safe to
insure proper security.
After you have entered the factory code, you will
need to turn the handle counterclockwise to open
the door. You will have 5 seconds to turn the
handle before the locking mechanism is
reactivated.
OPENING THE SAFE
Open the safe by turning the handle
counterclockwise
and pull the door open.
NOTE: The red reset button located on the
inside of the door, is covered with a removable
red cap. When you use the red reset button
while setting your own combination, remove
the cap to access the button.
Replace the cap securely over the reset button
after setting your combination. Failure to do
so will compromise the safety and security
of the safe.
2
16
40718-1704