Clearing The Memory; Battery Replacement; Locking The Safe - STACK-ON PS-10-B-12 Instrucciones

OPENING THE SAFE USING YOUR
FINGERPRINT
1. Press the ENTER button
light will glow around the fingerprint
scanner.
2. Place your finger on the scanner with
the same position and pressure you
used to record your fingerprint.
● The scan has been successful if
there is one "beep" and the green
light flashes.
● The scan has not been successful
if there are two "beeps" and both
lights flash. Try again from step 1.
3. Turn the knob to the right to open
the door.
NOTE: The knob must be turned all the
way to the left before trying to unlock the
safe using the fingerprint scanner. If you
change the batteries your recorded
fingerprints will be retained.

LOCKING THE SAFE

To lock the safe, close the door and turn the
knob to the left to the 12:00 position.
NOTE ON LOCKING THE SAFE: Because
the locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum of
6 seconds from the time the combination is
entered to lock the safe. Also, when
locking the safe, always make sure the
knob is turned completely to the left to the
12:00 position. If the knob is not turned to
the 12:00 position during the locking
process, the locking mechanism will not
lock.

CLEARING THE MEMORY

● Follow these steps to erase all
recorded fingerprints and change the
and a red
combination back to the factory preset
code 1-2-3-4.
1.
2.

BATTERY REPLACEMENT

● See also the section "GETTING
STARTED" at the beginning of these
instructions.
● NOTE: Do not mix old and new
batteries. Do not mix alkaline, standard
or rechargeable batteries.
This safe uses 4 - AA batteries. Under
normal use, batteries will last about 1 year.
When the battery is low, a red light will come
on warning you that the battery is low while
you are using the safe.
To replace the batteries, open the battery
compartment on the back of the door and
install all new batteries as shown in the
beginning of these instructions.
Press and hold down the Red Reset
button on the inside of the door for about
5 seconds and continue holding while
the green light flashes for about 12
times.
After the "beep" sounds and the green
light flashes, all the recorded finger prints
and your personal electronic combination
will be erased.
NOTE: The safes electronic combination
has now been changed back to the
factory preset code 1-2-3-4.
NOTE: For security you must
reprogram your combination after
resetting the safe to the factory
preset code.
4
24
40346-1306