Getting Started; Battery Installation - STACK-ON SHD-AOTT-BG-B Instrucciones

GETTING STARTED

When you first receive your safe you will
need to open the door with the key in order
to install the batteries. Batteries are
included and are located inside the safe.
To open the door with the key, first remove
the lock cover from the front of the faceplate
using a thin bladed flathead screwdriver.
Insert the key and turn clockwise.
The door will open automatically when the
key is in the open position.
NOTE: You must turn the key back to the
locked position before you can record a
fingerprint, close and lock the door.
NOTE: This key has also been provided in case
the batteries run low. If you lose your key, you
may purchase a replacement key by referencing
the serial number located under the removable
lock cover. See section at the end of this
instruction regarding replacement keys.

BATTERY INSTALLATION

NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or
rechargeable batteries.
This safe uses 4 - AA batteries. Under normal
use, batteries will last about 1 year.
NOTE: If the batteries are low the indicator light
will flash blue twice when you start scanning.
Replace with 4 new AA alkaline batteries.
Locate the batteries inside the safe. Open the
battery compartment on the back of the door
by pushing the tab in the direction of the arrow
and install the batteries. The light will flash
green with one beep (if the sound is turned on)
and the batteries are installed correctly.
Battery
Compartment
Reset Button
INSIDE SAFE DETAIL
NOTE: The reset button located on the inside
of the door, is covered with a removable cap.
When you use the reset button while
recording your fingerprint, remove the cap to
access the button. Use a pen tip to push the
reset button.
Replace the cap securely over the reset
button after recording your fingerprint.
Failure to do so will compromise the safety
and security of the safe.
2
16
40715-1705