STACK-ON PDS-1500 Instrucciones

PDS-1500
PDS-1505
Serial #:
Your Electronic Safe Combination:
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
Hardware Included:
(4) M6 x 15 mm (5/8" long) Machine Screws
(4) M6 Nylock Nuts
*(4) M6 x 50 mm (2" long) Lag Screws
*(4) M6 x 40 mm (1-1/2" long) Plastic Masonry Anchors
*(4) M4 x 25 mm (1" long) Screws
*(4) Washers
*(4) Drywall anchors
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
Phillips Screwdriver
10 mm Wrench
1/4" (7 mm) drill bit
*3/8" (9.5 mm) masonry drill bit for drilling into masonry
*3/16" (5 mm) drill bit for drilling into wood and wall studs
* For model PDS-1505 only
®
Instructions
GETTING STARTED
When you rst receive your new electronic safe you
will need to open the door with the key in order to
install the ba eries. Ba eries are included and are
located inside the safe.
To open the door with the key, rst remove the
lock cover from the front of the faceplate using a
thin bladed athead screwdriver as shown. Insert
the key and turn counterclockwise. Hold the key
in the open position and turn the knob to the
right to open the door.
NOTE: is key has also been provided in case
you lose or forget your security code or the
ba eries run low. If you lose your key, you may
purchase a replacement key by referencing the
serial number located under the removable lock
cover. See section at the end of this instruction
regarding replacement keys.
Locate the ba eries inside the safe. Open the
ba ery compartment on the back of the door by
pushing the tab in the direction of the arrow and
install the ba eries.
NOTE: e reset bu on located on the inside
of the door, is covered with a removable cap.
When you use the reset bu on while se ing
your own combination, remove the cap to
access the bu on. Use a pen tip to push the
reset bu on.
Replace the cap securely over the reset bu on
a er se ing your combination. Failure to do
so will compromise the safety and security of
the safe.
Lock Cover
40536-1506
1
18