Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

PS-15-05
Serial #:
Your Electronic Safe Combination:
IMPORTANT
Record the serial number from the tag on the
back of the safe or the tag on the inside of the lock
cover plate on the front of the safe.
Record your combination number.
Keep keys and combination in a secure place
away from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
Hardware Included:
(4) M6 x 15 mm (5/8" long) Machine Screws
(4) M6 Nylock Nuts
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
Phillips Screwdriver
10 mm Wrench
1/4" (7 mm) drill bit
®
Instructions
GETTING STARTED
When you rst receive your new electronic safe you
will need to open the door with the key in order to
install the ba eries. Ba eries are included and are
located inside the safe.
To open the door with the key, rst remove the
lock cover from the front of the faceplate using a
thin bladed athead screwdriver as shown. Insert
the key and turn clockwise. Hold the key in the
open position and turn the knob to the right to
open the door.
NOTE:
is key has also been provided in case
you lose or forget your security code or the
ba eries run low. If you lose your key, you may
purchase a replacement key by referencing the
serial number located under the removable lock
cover plate. See section at the end of this
instruction regarding replacement keys.
Locate the ba eries inside the safe. Open the
ba ery compartment on the back of the door by
pushing the tab in the direction of the arrow and
install the ba eries.
NOTE:
e reset bu on located on the inside
of the door, is covered with a removable cap.
When you use the reset bu on while se ing
your own combination, remove the cap to
access the bu on. Use a pen tip to push the
reset bu on.
Replace the cap securely over the reset bu on
a er se ing your combination. Failure to do
so will compromise the safety and security of
the safe.
Lock Cover
40659-1512
1
12
Tabla de contenido
loading

Resumen de contenidos para STACK-ON PS-15-05

  • Página 1 Ba eries are included and are located inside the safe. Instructions PS-15-05 To open the door with the key, rst remove the lock cover from the front of the faceplate using a thin bladed athead screwdriver as shown. Insert the key and turn clockwise.
  • Página 2: Entering Your Security Code

    ..key on www.stack-on.com under Customer Service. If you the electronic touch pad. You will have 3 seconds to write down your combination you must keep this press the ..
  • Página 3: Battery Replacement

    BATTERY REPLACEMENT SELECTING A LOCATION NOTE: Do not mix old and new ba eries. Do not is safe must be mounted into a drawer. For mix alkaline, standard or rechargeable ba eries. optimal safety and security, the safe should be installed in an isolated, dry and secure area.
  • Página 4 Keep this record of your serial number and your combination number in a a secure place separate from your safe. To order a replacement key set, follow the instructions on the a ached form. STACK-ON PRODUCTS COMPANY P.O. BOX 489 WAUCONDA, IL 60084 40659-1512...
  • Página 5 Verification of ownership is required in order to receive replacement key for your security product. In order to receive a replacement key to your security product: Complete the following form and send to Stack-On Products. Send a copy of your valid driver’s license along with the form.
  • Página 6 If Stack-On is properly notified during the three-year warranty period and, after inspection confirms there is a defect, Stack-On will, at its sole option, provide repair parts or exchange the product at no charge, or refund the purchase price of the product.
  • Página 7 Las baterías están incluidas y se encuentran dentro de la caja fuerte. Instrucciones PS-15-05 Para abrir la puerta con la llave , primero retire la tapa de la cerradura de la parte delantera de la placa frontal con un destornillador de cabeza plana de hoja delgada como se muestra.
  • Página 8: Introduza Su Còdigo De Seguridad

    3-8 dígitos, y combinación en la sitio web seguro con rmar su nuevo código pulsando la tecla ..www.stack-on.com bajo Servicio al Cliente . Si usted la super cie táctil electrónica. Usted tendrá 3 escribe su combinación debe mantener esta segundos para pulsar la tecla de ...
  • Página 9: Montaje Del Caja Fuerte

    CAMBIO LA BATERÌA SELECCIONAR UNA UBICACIÒN NOTA : No mezcle pilas viejas y nuevas . No mezcle Este caja fuerte debe estar montado en un cajón . pilas alcalinas , pilas estándar o recargables. Para la seguridad y la seguridad óptima , la caja de seguridad se debe instalar en una zona aislada , Este seguro utiliza 4 - pilas AA.
  • Página 10: Mantenimiento

    Para pedir un juego de llaves de repuesto, siga las instrucciones en el formulario adjunto. STACK-ON PRODUCTS COMPANY P.O. BOX 489 WAUCONDA, IL 60084 40659-1512...
  • Página 11: Solicitud De Llave

    Para poder recibir su llave de reemplazo de su gabinete de seguridad: Llene y envíe esta solicitud a Stack-On Products. Envíe copia de su licencia de conducir junto con la solicitud. Envíe copia del recibo mostrando la fecha original de compra.
  • Página 12 Wauconda, IL60084 [email protected] Si se notifica debidamente a Stack-On durante el período de garantía de tres años y, después de la inspección se confirma que existe un defecto, Stack-On, a su exclusiva opción, proporcionará piezas de repuesto o cambiará el producto sin cargo, o reembolsará el precio de compra del producto.

Tabla de contenido