Balanced Body Allegro 2 Instrucciones página 10

Note: Once the pin is in the locked position, the next steps are
made easier if the head end of the Reformer is raised up onto a
stable object.
8. From the bag of parts,
assemble one of the bolts,
washers and square sliders
(see Figure I).
9. It is important that this
bolt assembly is installed
on the side of the foobar
without the locking pin
installed
10. Install the bolt assembly
by hand as shown in Figure
J. You will need to align
the square slider of the
bolt assembly with the
rectangular slot, finger-
tighten.
You will need to lift and jiggle
the footbar while tightening
the bolts by hand. You can use your other hand, shoulder, or
have a friend jiggle the footbar up and down as you turn the
bolt with your fingers.
The bolt will thread in easily until it is completely installed.
The bronze washer on the bolt will still be able to spin when
the bolt is tight.
DO NOT use the wrench until the bolt is completely screwed
in by hand.
Once you are sure the bolt is completely threaded in, use the
long arm of the included wrench to tighten. The bolt should
be secure, but do not over tighten.
11. After installing the first bolt assembly, remove the locking
pin that was holding the footbar in position. Now install the
second bolt assembly and tighten with the wrench.
12. After the bolts are installed put the locking pins back into
"storage" position. You can also remove the adhesive
markers. The footbar is now ready to use.
9
Figure I
After bolts are
installed, return the
locking pin to it's
storage position.
.
Figure J
E. INSTALL SPRING COLLARS
Balanced Body springs come pre-installed. To install spring
collars disconnect the spring from the foot-end of the Reformer.
Slide the slot of the collar on to the neck of the spring as shown
in Figure K. Twist the collar and push up to secure.
Figure K
Bolt assembly in threaded hole.