Supply Dispenser; Cycle Selection; Cycle Execution - Alliance Laundry Systems UW35P2 Manual De Operación

Operation
Loading
(Continued)
Note: When washing items which may
disintegrate or fragment, such as mop heads or
sponges, use laundry nets to prevent drain
blockage.

Supply Dispenser

Dry supplies are placed in the supply dispenser
compartment cups prior to the start of each
cycle.
Liquid supplies can be injected directly into
the supply dispenser by an external chemical
supply system.
Note: Supply dispenser compartment cups
must not be removed when an external
chemical injection supply system is attached to
the washer-extractor.

Cycle Selection

Note: Press keys at their centers just hard
enough to activate them.
Find the cycle number of the desired wash
cycle from the preprogrammed cycle charts in
the Programming section of this manual. Cycle
numbers must be two-digit numbers from
01 to 39.
Press the numbers desired on the keyboard
and note that these numbers are displayed
after "NEXT."
20
When keys are pressed on the keyboard, a
beep will be heard. If an error is made, press
the numbers again. As numbers are entered,
they move from right to left on the display.
Note: If the washer-extractor is equipped with
both steam and electric heat, the selector
switch on the right side of the control module
must be in the correct position for the desired
heat source, down for steam heat, up for
electric heat.

Cycle Execution

To start the selected cycle, press the Start key.
If the selected cycle number is not in the
computer memory, the display will show
"NCYC." If this happens, select another cycle.
Otherwise, the display will now show the first
step. For example, if the display reads "HL0l,"
"HL" represents a hot fill to low level, and
"01" indicates that this is the first step of
the cycle.
As the cycle proceeds, the display will show
the function being executed, the step number,
and the cycle number selected. Pressing the
Edit Cycle key while the cycle is running will
cause the display to show the remaining cycle
time in minutes. Pressing this key again will
return the display to normal.
To begin the cycle at any step other than the
first step, press the Advance key to advance
through the cycle to the desired starting point.
(The Advance key is enabled at the factory
and can be disabled at the laundry site.) Then
press the Start key.
F232090