Alliance Laundry Systems UW35P2 Manual De Operación página 34

Programming
Programming Tutorial
24. Press the Enter key. The display flashes
"SDLY" for one second.
The display will then read "0M-00S,"
allowing the programmer to enter the time
for a slow down delay (coast).
At some point in the future–to have the
basket coast before it stops, enter the
desired coast time (up to 99 seconds).
However, do not enter a time now. That
would cause a coast before a higher spin
speed (which will be the next step).
For no coast, press the Enter key.
25. The next step is to program a high-speed
spin.
a. Press the High Speed key once. The
display will read "HS1139."
b. Press the Enter key. The display will
read "M---S."
c. Enter a length of time for the high-
speed spin (six minutes). Press key 6.
The display will read "6M-00S."
Note: High-speed spin is preceded
automatically by medium-speed spin for 30
seconds for nonvariable-speed UW rigid-
mount models.
26. Press the Enter key. The display will flash
"SDLY" for one second. ("SDLY" also
displays during the entire actual
coastdown.) The display will then read
"0M-00S," inviting the programmer to
enter a time for the slow-down delay
(coast). If the application requires that the
basket coast before it stops, enter the
desired coast time (30 seconds here) and
32
(Continued)
press the Enter key. If no coast is desired,
press the Enter key only. The display will
read "1239."
Note: A slow-down delay of 30 seconds
minimum should be programmed after each
high-speed spin. All the preprogrammed and
optional cycles in this manual reflect this
practice.
27. The previous step ends the tutorial. Cycle
39, consisting of 11 steps, has been
completely programmed.
To end the cycle, turn the program mode
switch located on the left side of the
control module to the RUN position and
remove the key. The display will then
read "NEXT."
The programmer can now select Cycle 39
and press the Enter key to run the cycle, if
desired; or a cycle of the programmer's
own design can be programmed.
F232090