Programming A Drain Step; Programming A Flush Step - Alliance Laundry Systems UW35P2 Manual De Operación

To program a soak with temperature step
use the following procedure:
a. Press the Heat key after pressing the
Soak key. The display will read either
"080Fcc" or "025Ccc," depending
on whether Fahrenheit or Centigrade
is prompted.
b. Enter the temperature desired for the
machine to maintain during the soak
step. Three digits must be entered for
the temperature. If the desired
temperature is less than 100 degrees,
the first digit should be 0. The valid
temperature range is 80–200 degrees
Fahrenheit and 25–93 degrees
Centigrade. The computer will not
accept temperatures outside of this
range. If 100 degrees Fahrenheit is
selected, the display will read
"100Fcc."
3. Press the Enter key. The display will read
"H---M." Now assign the soak step the
desired time in hours and minutes. During
the soak step, no agitation will occur. The
WE-6 microcomputer will maintain the
water level during the soak cycle at
whatever previous level was programmed.
4. Press the Enter key and go to the next step
in the cycle.

Programming a Drain Step

1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press the Drain key. The display will read
"D-nncc."
3. Press key 1 for a regular drain to sewer or
a floor drain. The display will read
"D1nncc."
F232090
Programming
4. Press the Enter key. The display will read
"M---S." Now assign the time which will
allow the machine to drain to empty.
This is an alarm time. The machine should
drain in 30 seconds under normal
conditions. The recommended drain time
is one minute. Drain times of more than
one minute are not recommended.
5. Press the Enter key and go to the next step
in the cycle.
Note: When programming a drain step, it is
important to select Drain 1. Drain 2 is not
available on the UW60 2-speed or 3-speed
washer-extractors.

Programming a Flush Step

When the Flush key is pressed, the drain will
remain open and the basket will rotate in slow
speed forward only. Water is added only
through the door spray nozzle.
1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press a water temperature key, either
Cold, Hot, or Warm. If the Cold key is
pressed, for example, the display will read
"C-nncc," etc.
3. Press the Flush key. The display will read
"CFnncc," "HFnncc," or "WFnncc,"
depending upon the temperature selected.
4. Press the Enter key. The display will read
"M---S." Now assign the desired flush
time in minutes and seconds.
5. Press the Enter key and go to the next step
in the cycle.
45