Start-Up; Opening Door; Loading - Alliance Laundry Systems UW35P2 Manual De Operación

Start-up

Turn on the main power source (circuit breaker
or cut-off switch on the wall).
When AC power is turned on, the display will
show the program (ROM) identification code.
This identification code will appear for
approximately five seconds. Then the
computer display will flash "POWER" and
"WAIT" alternately for 30 seconds.
The display will then show "NEXT00" to
indicate that a cycle can be selected. This
display will be shown at all times that
power is on between cycles, indicating that the
door-unlock solenoid will function if the door-
unlock button is pressed. The washer-extractor
is then ready for loading and unloading.

Opening Door

Use left hand to press and hold the door unlock
button located on the lower right front of the
control panel. See Figure 5.
Figure 5
F232090
Use right hand to turn door handle clockwise
and swing the door left to open. See
Figure 6.

Loading

Load the machine to full capacity whenever
possible, but do not exceed the rated dry-
weight capacity of the machine if the fabric to
be washed is quite dense, closely woven, and
heavily soiled. Overloading can result in an
inferior wash. The operator may need to
experiment to determine load size based on
fabric content, soil content, and level of
cleanliness required.
Partial loads are a waste of energy, water,
and chemicals, and cause greater machine
wear than full loads. Partial loads also
increase the possibility of a severe out-of-
balance condition.
MD003J
When loading is complete, ensure that all
fabric is inside the basket. Then close and lock
the door.
Operation
MD004J
Figure 6
19