Programming No Reversing; Programming A Soak Step - Alliance Laundry Systems UW35P2 Manual De Operación

Programming
Step Programming
3. Enter the desired temperature for the load
to cool down to. Three digits must be used
for the temperature. If the desired target
temperature is less than 100 degrees, the
first digit must be "0." The valid
temperature range is 80–200 degrees
Fahrenheit and 25–93 degrees Centigrade.
The computer will not accept temperatures
outside of this range. (The cool-down rate
will be affected by the temperature of the
cold water available.) If 100 degrees
Fahrenheit is selected, the display will
read "100Fcc."
4. When the desired cool-down temperature
is displayed, press the Enter key. The
display will show "H--M." Now enter the
maximum time in hours and minutes
for the computer to reach the target
cool-down temperature.
Experimentation may be necessary to
determine the exact time required with
each installation to enable the computer to
reach the target cool-down temperature.
Use the edit feature to revise the Wash 5
step during the experimentation process.
When the computer performs the Wash 5
step, the temperature in the sump must be
greater than the target cool-down
temperature. Otherwise, the computer
will advance past the Wash 5 step.
5. When the desired time is displayed, press
the Enter key and proceed with the next
step in the cycle.

Programming No Reversing

All agitation is programmed by first pressing
the Wash key and then pressing either key 1,
2, 3, 4, or 5 for the type of agitation desired
during the wash step.
44
(Continued)
If no reversing is desired (rotation continuous
in one direction), use the following procedure:
a. Press the Wash key.
b. Then press either key 1 or key 2.
c. Then press the No Reverse key.
d. Then press the Enter key.
The display will show either "W1nncc" or
"W2nncc," depending on the kind of agitation
selected. The display will not indicate that the
no-reverse option was selected, but the
machine will obey the instructions.
Note: The no-reverse option is normally used
with Wash 1 steps but may be used with other
appropriate functions. The no-reverse option
may be programmed in wash, supply, heat, and
overflow steps. The No Reverse key must be
pressed just prior to pressing the Enter key
when programming a step. See No. 4 under
Programming a Wash Step.

Programming a Soak Step

1. The computer must be in the PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
(The previous step should have been a fill
and/or supply step.)
2. Press the Soak key. The display will
read "SKnncc."
With machines equipped with auxiliary
heat (optional steam or electric), it is
possible to program a soak-with-
temperature step. During such a step, the
machine will soak for the time
programmed at the temperature
programmed and will maintain that
temperature throughout the step.
F232090