Mitsubishi Electric City Multi PLFY-P-VEM-E Manual De Instalación página 9

Types of transmission cable Shielding wire CVVS or CPEVS
Cable diameter More than 1.25 mm²
Length Less than 200 m
Types of remote control cable Shielding wire MVVS
Cable diameter 0.5 to 1.25 mm²
Add any portion in excess of 10 m to within the
Length
longest allowable transmission cable length 200 m
M1 M2 M1 M2 S 1 2
TB3 TB5
M1 M2 M1 M2
TB3 TB5
CN90
M1 M2 Pair No. M1 M2
0
TB3 TB5
9
Pair No.
0
A
SW14 SW12 SW11
SW21
ON
OFF
1 6
BRANCH 10s 1s
No. DIGIT DIGIT
M1 M2 S 1 2
TB15 TB5 TB15
S M1 M2 S
TB5
CN90
S 1 2 Pair No. M1 M2 S 1 2
0
TB15 TB5
9
SW22 SW1 SW2 SW3
ON
OFF
1 4 1 0 1 6 1 0
Types of remote control cable 2-core cable (unshielded)
Cable diameter
Length
the connecting cables, refer to the outdoor unit installation manual.
core cable. If the distance is more than 10 m, use a 1.25 mm
1 MA Remote controller
2-wire)
2 M-NET Remote controller
polarized 2-wire)
3 Wireless remote controller (When installing wireless signal receiver)
troller board.
controller, connect TB15 each with the same number.
TB15 controller. (In initial setting of indoor unit and wireless remote controller, Pair No.
is 0.)
A Terminal block for indoor transmission cable
B Terminal block for outdoor transmission cable (M1(A), M2(B),
C Remote controller
D wireless signal receiver
E wireless remote controller
(Be sure to operate with the main power turned OFF.)
over 10, and setting branch numbers.
1
How to set addresses
Example: If Address is "3", remain SW12 (for over 10) at "0", and match
SW11 (for 1 to 9) with "3".
2
How to set branch numbers SW14 (Series R2 only)
Match the indoor unit's refrigerant pipe with the BC controller's end connection
number.
Remain other than series R2 at "0".
can be used to set unit addresses and branch numbers at will.
referring to the Data Book.
A
Controller board
0.3 to 1.25 mm²
Less than 200 m
2
(S))
2
-
9