cascade corporation 20G-77G Instrucciones De Instalación página 4

I
NSTALLATION
Follow the steps shown to install the attachment on
the truck. Read and understand all WARNING and
CAUTION statements. If a procedure is not understood,
ask your supervisor, or call the nearest Cascade Service
Department for assistance.
1
Attach overhead hoist
A
Remove banding, use multiple chains
to stabilize the attachment while lifting.
Set the attachment upright on pallet.
B
Remove bolt-on lower mounting hooks
(if equipped).
2
Unlock quick-change lower
mounting hooks
A
Remove pin and drop hooks into unlocked
position.
B
Reinstall pin in lower hole.
B
2
A
A
Guide
®
e
a d
s c
c a
- 1
1 4
5 5
6 7
C -
LH Lower
Hook
Pin
WARNING: Verify that the overhead
hoist and chains or straps are rated for
the weight of the attachment. Refer to
nameplate for attachment weight.
B
16 mm offset
on top provides
max. hook
clearance.
A
CL2795.eps
NOTE: Guides can be reversed to
change hook-to-carriage clearance
(See lower hook installation, Step 6).
CL0097.eps
Tighten capscrews to:
CL II, CL III – 225 Nm
CL IV – 435 Nm
6033701-R6 EN