Assembling And Operating The Appliance - Silvercrest SFE 450 C3 Manual Del Usuario

Assembling and operating the appliance

■ Before using the appliance for the first time, clean all component parts
thoroughly as described in the section "Cleaning and care".
■ Select a safe and secure positioning for the juicer. For optimal handling we
recommend that the appliance is positioned with the power cable 8 running
from the rear of the appliance to the wall socket. All operating elements can
now be directly and easily handled:
–
–
–
WARNING! RISK OF INJURY!
Ensure that the appliance is switched off and the plug 8 removed from the
►
wall socket before assembling the appliance.
1) Place the juice tank 5 on the appliance base 7, so that the three catches
and the juice outlet 6 grip into in the recesses.
2) Place the filter w on the drive shaft e and press it down so that it audibly
clicks into place. Ensure that it is firmly seated before continuing with the
assembly.
3) Slide the container for fruit and vegetable pulp q from below under the
outlet (see fold-out page).
4) Place the lid 3 onto the juice tank 5, so that the feed tube 2 is sitting
above the blades of the filter w.
5) Ensure that the lid 3 is sitting firmly in the recess on the juice tank 5.
Lift the clamps 4 and clip them into the notches on the lid 3.
6) Press the lower part of the clamps 4 against the appliance until they click
into place.
7) Push the foam separator z into the juice collector t and put the lid on.
Place the separate juice collector t next to the appliance so that the juice
outlet 6 protrudes into the separate juice collector t.
8) Insert the plug 8 into a mains power socket.
SFE 450 C3
the On/Off switch 9 at the front,
the container for fruit and vegetable pulp q on the left,
the juice outlet 6 on the right.
GB │ IE │ 7 ■