Before Use; Operating The Appliance For The First Time - Hilti VC 20 Manual De Instrucciones Original

Recommended minimum conductor cross-section and maximum supply cord length for 120V supply
voltage
Cord
Conductor cross-section
Conductor cross-section
Cord length
Cord length
6

Before use

DANGER
Electrical hazards. Fatal or serious injury may result if the vacuum cleaner is not correctly connected to the
electric supply.
▶ Connect the vacuum cleaner only to a properly earthed/grounded power source.
CAUTION
Risk of injury presented by the appliance running away out of control. The vacuum cleaner may run
away out of control if the wheel brakes are not engaged.
▶ Engage the wheel brakes so that the vacuum cleaner stands securely.
6.1

Operating the appliance for the first time

Plastic dust bag: For collecting harmless dust types:
Plastic dust bag for mineral dust or paper dust bag for wood chips:
> Class M for picking up dust types with an exposure limit value of ≥ 0.1 mg/m3
> Class L or M for picking up dust types with an exposure limit value of ≥ 1 mg/m3
1. Open the two catches.
2. Lift the vacuum cleaner top section away from the waste material container.
3. Remove the accessories and packaging from the waste material container.
4. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
5. Check to ensure that the vacuum cleaner top section is fitted correctly and secured.
6. Connect the suction hose to the appliance.
6.2 Fitting a paper dust bag for picking up wood chips
Sharp pointed objects may pierce through the dust bag.
Check that no objects have pierced through the dust bag.
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the suction head off the waste material container.
4. Fit the new paper dust bag into the adapter and insert these in the waste material container.
5. Fit the vacuum cleaner top section onto the waste material container.
6. Close the two catches.
7. Check to ensure that the vacuum cleaner top section is fitted correctly and secured.
8. Connect the suction hose to the appliance.
6.3 Fitting a plastic dust bag
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the suction head off the waste material container.
4. Fit a new plastic dust bag (see instructions printed on it) in the waste material container.
5. Set the suction head on the waste material container and close the two catches.
24 English
AWG 16
1,31 mm²
2,58 kcmil
25 m
75 ft
3
AWG 14 AWG 12
2,08 mm² 3,31 mm²
4,11 kcmil 6,53 kcmil
30 m 50 m
100 ft 150 ft
2
2190557
*2190557*
AWG 10
5,26 mm²
10,4 kcmil
100 m
250 ft