Tabla de contenido
SYMBOLS & TERMS
C - - A Toaster is set on Celsius.
F - - A Toaster is set on Fahrenheit.
A L -
Alarm Level setting 1-4.
Sound Button: Used with timer button
and temperature button to set alarm
level.
Timer Button: Used to view time in run
mode. Used to set time in program mode.
Temperature Button: Used to view set
point temperature in run mode, and used
to set the set point temperature in
program mode.
Up Arrow: Used to set time, sound and
temperature in program mode.
Down Arrow: Used to set time, sound,
and temperature in program mode.
ENERGY SAVING MODE
To conserve energy during non-toasting periods,
pull the toaster handle down, so that the timing
cycle activates. When the audio alarm goes off,
indicating that the toasting time is complete, DO
NOT pull the handle up. Allow the audio alarm to
sound until the alarm shuts off, the display will
alternately flash "Stand" and "By", indicating the
toaster is in the energy savings mode. The toaster
platens will continue to maintain the programmed
operating temperature, raising the toaster handle
will put the toaster back into the operation mode.
FACTORY PRE-SET
Prince Castle's Solid State Digital Display toasters are
pre-set at the factory.
If your toaster model is set for a 35 second toast time,
then the temperature is pre-set and calibrated to
215°C.
If your toaster model is set for a 55 second toast time,
then the temperature is pre-set and calibrated to
204°C.
SET-UP
1. Refer to the nameplate on the control box for the
proper operating voltage. Connect the toaster to a
grounded receptacle that matches the nameplate
voltage information. Press the power switch to the
on position, allow the unit 30 minutes to reach
2000 McDonald's Corporation
All Rights Reserved
operating temperature.
2. The toaster is factory-set to display temperatures
reading in Celsius. When the toaster is turned on,
the digital display on the control box will read C--A
for Celsius, and the "A" will begin to count down 9
seconds. During this countdown, you can change
the temperature display from Celsius to Fahrenheit
figure 1
readings. To change temperature display, press
and hold the temperature button for six seconds.
See figure 1.
3. During the pre-heat cycle, the display will read -
L O -. When the platen temperature reaches
figure 2
149°C (300°F), the display will begin to show
the actual platen temperatures throughout
the toasting cycles. See figure 2
Sound Level Adjustment
The audio alarm has four sound levels.
1. Press and hold the time button and temperature
buttons simultaneously. The display will show the
current sound level. The toasters are factory set at
level 4, and the display will read, A L 4 for Alarm
figure 3
Part No. 411-543 Rev C
5
F - -
- L O -
1 4 9
A L 4
Printed in the
United States of America
Tabla de contenido
Solución de problemas
