Honda XRE 190 Manual Del Propietário página 144

XRE 190
Installation
1. To install the rear wheel, reverse the removal
procedure.
Take care to prevent the brake caliper from
scratching the wheel during installation.
n
otice
When installing the brake caliper, carefully fit the
brake disc between the pads to avoid scratching
them.
2. Make sure that the lug on the swingarm is located
in the slot of the brake caliper bracket.
1
2
3
1. Brake caliper bracket
2. Swingarm
3. Rear axle nut
4. Slot
5. Lug
5
4
3. Adjust the drive chain slack. (page 48).
4. Tighten the rear axle nut.
torque: 93 N.m (9.5 kgf.m, 69 lbf.ft)
5. After installing the wheel, apply the brake pedal
several times, then check if the wheel rotates freely.
Recheck the wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for installation,
see your dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
59