Changing Engine Oil - Honda XRE 190 Manual Del Propietário

XRE 190

changing Engine oil

Changing the oil requires special tools. We recommend
that you have your motorcycle serviced by your dealer.
1. If the engine is cold, idle the engine for 3 to
5 minutes.
2. Turn the ignition switch off, stop the engine and
wait for 2 to 3 minutes.
3. Place your motorcycle on a firm, level surface.
4. Place a drain pan under the drain bolt.
5. Remove the oil fill cap/dipstick, drain bolt, and
sealing washer to drain the oil.
Discard the oil at an approved recycling centre.
1
1. Sealing washer
2. Drain bolt
6. Install a new sealing washer onto the drain bolt.
Tighten the drain bolt.
torque: 30 N·m (3.1 kgf·m, 22 lbf·ft)
7. Fill the crankcase with the recommended oil (page
30) and install the oil fill cap/dipstick.
Required oil
when changing oil:
1.0 litres (1.1 us qt, 0.9 Imp qt)
8. Check the oil level (page 42).
9. Check that there are no oil leaks.
43
2