Tube Repair And Replacement - Honda XRE 190 Manual Del Propietário

56

tube Repair and Replacement

If a tube is punctured or damaged, you should replace
it as soon as possible. A tube that is repaired may not
have the same reliability as a new one, and it may
fail while you are riding.
If you need to make a temporary repair by patching
a tube or using an aerosol sealant, ride cautiously
at reduced speed and have the tube replaced before
you ride again.
Anytime a tube is replaced, the tyre should be carefully
inspected as described.
W
!
Arning
Riding your motorcycle with a temporary tyre or
Q
tube repair can be risky. If the temporary repair
fails, you can crash and be seriously injured or
killed.
If you must ride with a temporary tyre or tube
Q
repair, ride slowly and carefully and do not
exceed 50 km/h (30 mph) until the tyre and
tube are replaced.
Removing wheels
Follow these procedures if you need to remove a
wheel in order to repair a puncture.
When removing and installing the front wheel, be
careful not to damage the wheel speed sensor and
pulser ring.
 Front wheel
Removal
1. Place your motorcycle on a firm, level surface.
2. Support your motorcycle securely and raise the
front wheel off the ground using a maintenance
stand or a hoist.
3. Remove the front axle nut.
1
4
XRE 190
1. Pulser ring (XRE
190 ABS only)
2. Left side collar
3. Wheel speed
sensor (XRE 190
2
ABS only)
4. Front axle nut
3