Standard Equipment; Equipment And Optional Accessories - Hupfer TTW/V 1/24 B-EN-115 Instrucciones De Uso

Section 3
Page 12
3.4.3

Standard Equipment

The tray transport trolley is entirely made of stainless steel, benefits from double-walled insulation and has
a welded interior.
The side walls are equipped with seamlessly deep-drawn beads at a distance of 4.5" (115 mm) (optionally
also 3.7" (95 mm) or 4.1" (105 mm)).
The side walls of the tray transport trolleys can be equipped with an embossed tilt protection when they are
not used together with inductive docking stations.
Smooth surfaces and the seamless fabrication of the side and middle walls enable an easy cleaning of the
interior. The middle walls can be removed for a thorough cleaning of the appliance.
You can swing the hinged doors to an angle of approx. 270° and lock them. The 2-point locking mechanism
safely locks the doors during transportation.
The design with vertical push bars in the corners of the trolleys ensures that they can easily be manoeu-
vred with the doors open or closed without any difficulty, even when fully loaded.
The corrosion-resistant swivel casters with total locks and fixed casters made of stainless steel ensure an
optimal movement and manoeuvrability of the tray transport trolley.
The lower peripheral frame made of shock-resistant plastic offers an optimal bumper and it is disconnected
in the middle on the right and left sides for the optional installation of the coupling and drawbar.
3.4.4

Equipment and Optional Accessories

You can install and fit the tray transport trolleys with optional accessories in various ways.
§
Gallery:
The gallery and a non-slip pad make it possible to use the top of the trolley as an additional and se-
cure storage surface. The top of the trolley may be loaded with up to 55 lbs (25 kg).
§
Central total brake:
The optional central total brake provides a firm hold during operation and standby mode. One single
foot control locks the swivel casters of the tray transport trolley.
§
Casters that can only roll in one direction (Rifix):
Casters fitted with Rifix can be fixed to roll in one direction only. This significantly facilitates the di-
rectional stability, e.g., during traction operation.
§
Coupling and drawbar:
For the connection of several tray transport trolleys for traction operation. The simple version is also
available in combination with casters that are movable in only one direction. The second option with
friction damping enables the directional stability during traction operation even in tight bends.
§
Shelf for beverage containers with lengthwise or crosswise insertion.
§
Stacking basket, stainless steel, plastic-coated, lengthwise insertion.
§
Card holder
§
Connecting components for induction docking stations.
§
Trays:
Tray transport trolleys are intended for the use of EN trays and GN trays. Suitable systems are e.g
HUPFER
§
Induction crockery
Generally, all standard induction crockery can be used in combination with tray transport trolleys
and induction docking stations. Since the manufacturers sometimes use different coatings, the pow-
er consumption is always dependent from the used crockery when the device setting is identical.
When it deviates from the standard then a fine tuning between the device and the crockery is al-
ways necessary. This fine tuning must be done by the manufacturer or the service technicians au-
thorized by the manufacturer.
On request, recommendations for induction crockery are made available. Isolating covers for the
main course dishes (deep plate Ø 9.4" to 10.2" (240 to 260 mm) and stew bowls Ø 6.7" to 7.5" (170
to 190 mm) are also available as a special accessory.
Tray transport trolley
TTW/V
®
SDS trays.
Description and Technical Data
Appliance Description
91275972_A1