of the tyre.
2) Move the control console to working
position C.
3) Rotate the wheel and at the same time move
the hook tool forward inserting it between the
rim and bead until it is anchored to the bead
(see Fig. 22).
4) Move the rim about 4-5 cm away from the
tool making sure the bead does not detach
from the tool.
5) Move the hook tool outward so that its red refer-
ence dot is moved near the external rim edge.
6) Move the control console to working
position B.
7) Insert the lever (A, Fig. 22) between the rim
and the bead to the right of the tool.
8) Keeping the lever pressed down, lower
the wheel to bring the rim edge about 5 mm
52
A
22
from the hook tool.
9) Turn the wheel anticlockwise keeping the
lever pressed down (A, Fig. 22) until the bead
comes out completely.
10) Position the tool holder arm in the non-
working position and move it to the inner side
of the wheel.
11) Move the control console to working
position D.
12) Turn the hook tool 180°, insert it between
the rim and bead (see fig. 23) and move it
until the bead is near the front rim edge (it is
recommended to perform this operation turn-
ing the wheel at the same time).
13) Move the rim about 4-5 cm away from the
tool making sure the bead does not detach
from the tool.
14) Move the control console to working
position B.
15) Move the hook tool so that its red reference
- E
nglIsh
23
- User Manual TB125