Maintenance - Mondolfo Ferro TB125 Manual De Uso

MAINTENANCE

WARNING
MONDOLFO declines all liability for claims
deriving from the use of non-original spares
or accessories.
WARNING
Unplug the machine from the socket and
make sure that all moving parts have been
locked before making any adjustments or
maintenance work.
WARNING
Do not remove or modify any parts of this
equipment except in the case of service
operations.
WARNING
Before removing unions or pipes, make sure
that the fluids are not pressurised.
If pressurised oil escapes, it can cause seri-
ous injury.
WARNING
Keep the work area clean.
Do not use pressurised water jets to wash
the machine
You are strongly advised not to use compressed
air to clean moving components.
When cleaning the area take all possible
measures to avoid spreading dust, as far
as possible.
For perfect operation and greater duration
of your tyre changer, following these instruc-
tions carefully:
1) Lubricate the following parts periodically
after cleaning them thoroughly with naphtha:
- the various joints on the turntable
- the tool holder arm guide
- the carriage guide plate
2) Grease the turntable holder arm lifting
cylinder and arm joint periodically using the
grease nipples (see fig. 39).
Use ordinary lubricating grease.
N.B. To reach the grease nipple on the arm,
first remove the plastic cap (A, Fig. 39) un-
64
screwing the two self-threading screws (B,
Fig. 39).
3) Periodically check the oil level in the
hydraulic power unit using the dipstick (A,
Fig. 40).
If the level is below the minimum notch, top
up with ESSO NUTO H 32 or an equivalent oil
(ex. : AGIP OSO 32, SHELL TELLUS OIL 32, FINA
HYDRAN 32, API CIS 32).
Unscrew the cap, add the oil and then close
the cap.
4) Periodically check the oil lever in the gear
unit that, when the turntable holder arm is
completely lowered, should never completely
uncover the sight glass on the gear unit casing.
- E
nglIsh
B
A
39
A
40
- User Manual TB125