The Front Loader - Siku SIKUCONTROL32 6778 Instrucciones De Uso

The new vehicle is automatically saved by the system
and so you can drive it immediately. The vehicle that
was last added is always the operational one. If you
now want to switch between the vehicles stored on the
same level, press the level A button once (or more than
once if there are more then two models). Every time
this button is pushed, the next model that is saved is
triggered.
d) Deleting the model from memory
Turning off the remote control module deletes the mo-
dels stored in the internal memory of the module. Ho-
wever, a system restart as in section (a) or (b) adds the
models again. If a vehicle is switched off with its opera-
ting switch, then it is automatically deleted from the list
of active models in the remote control module, and can
be added to any other remote control module. If the
model is turned off by accident, or if a battery has to be
changed, then once it has been switched back on, the
model can be reintegrated back into the module via the
procedure in section (c).

5. The front loader

This high quality SIKUCONTROL32
with an electronically controllable front loader.
The front loader can be operated using the two thumb
wheels to the right and left of the operating switch. The
right hand thumb wheel moves the entire loading arm
up or down. The shovel is tipped using the left hand
thumb wheel. The shovel is to be removed from the front
loader using a handle. To make this possible, the shovel
is equipped with a snap-in-place system.
Removing the shovel:
Move the front loader into the dismantling position
using the D button. Pull the shovel from the loading arm
and from the tipping bar, using gentle pressure. When
doing so, hold the lever on the tipping bar between
your thumb and forefinger.
14
Attaching the shovel:
Use the D button to move the holder for the front loa-
der into the mounting position. Push the shovel onto the
loading arm by applying a little pressure. Hold the lever
on the tipping bar between your thumb and forefinger,
and also apply gentle pressure to the shovel.
In addition, the front loader can be moved into a par-
allel mode with the P button. In this mode, the attached
device is always moved parallel to the ground, thus ma-
king it easier to stack pallets, bales of hay, stones, etc. In
this mode the tipping function of the attached device is
deactivated. By pressing the P button again, this mode
is deactivated.
General functions of the model
• Travel forwards/reverse - proportional
• Steering left/right - proportional
• Raising and lowering the front loader -
• Tipping function of shovel - proportional
• Rear coupling controlled electronically -
model is fitted
• H eadlights and rear lights (can be switched on
• Right/left indicators (can be activated separately)
• All-round lights on cab roof
• Floodlights on the cab and radiator grille
• The floodlights are activated by pressing the
proportional
proportional
and off)
(can be switched on and off)
at front (can be switched on and off).
"Headlights" button multiple times.