Before Use; Installation; Start-Up; Connecting The Compressed Air Tool - Parkside PDKS 6.0 A1 Instrucciones De Utilización Y De Seguridad

Before use / Start-up / After initial use

Before use

Installation

The device itself is fully functional at delivery. Using
the device may require (unless already installed) in-
stalling a threaded plug nipple
under technical details for the fit / size).
Wrap the threaded plug nipple
tape (not included) before screwing it into the
air tool. Wrap the tape around the thread as
tight as possible. This will minimise the likelihood
of air leaking and optimise the work process.
Now screw the threaded plug nipple
the power tool.
Tighten the threaded plug nipple
tool with a size 14 key using moderate force
(see Fig. A).
Adjusting the compressed air supply and
connections
Only use filtered, lubricated and regulated
compressed air.
Connect to the compressed air system using the
method shown in Figure B. This will increase
the effectiveness and life of the tool.
Set your compressor to the working pressure
specified for the device under technical data.
Please note, on average the pressure for 10 m
of hose will decrease by about 0.5 bar.
dangerous! Never exceed the specified
pressure!
Add a few drops of air tool oil or SAE 10–20
engine oil to the compressed air connection of
the air tool before first use and in regular intervals.
Using other oil (particularly higher viscosity) will
result in damage or even total loss of the device.

Start-up

Connecting the
compressed air tool
Verify the work piece is correctly supported.
40 GB/MT
110140_par_Druckluft-Saege PDKS 6.0 A1_content_ES_IT_PT.indd 40
(note the data
5
with Teflon
5
into
5
to the air
5
Excessive pressure is
Connect to compressed air by pushing on the
quick couple of the hose using a little force
(see Fig. C).
Always verify the compressed air hose is properly
connected (see Fig. D). A loose hose whipping
about out of control presents a major hazard.
The threaded plug nipple
seated for the same reason. This must also be
checked.

Cutting

Note: The trigger
features a safety stop. Using
4
the trigger
requires pushing the lever on the trig-
4
ger (safety stop) forward whilst pushing down
4
on the trigger .
4
Activate the trigger
4
Note: Metal slivers flying about can be very
dangerous!
Note: If the compressed air supply is tempo-
rarily cut off due to power failure or temporary
compressor failure, immediately release the
trigger . You must now first pull the saw all
4
the way out of the work piece to continue work-
ing. You can then continue working.
Always check the saw blade position after
2 minutes of continuous operation.
After finishing the task, release the trigger
stop the saw from running.

After initial use

Once the task has been finished the device must be
disconnected from the compressed air connection.
This first requires the pressure to be completely re-
leased from the lines.
Briefly activate the trigger
release any remaining compressed air.
must be firmly
5
to operate the saw.
to
4
on the device to
4
02.07.15 11:20