Replacing The Saw Blade; Cleaning And Storage; Lubricating The Air Saw; Storing The Air Saw - Parkside PDKS 6.0 A1 Instrucciones De Utilización Y De Seguridad

Replacing the saw blade

Immediately replace the saw blade
or defective.
Always be sure the compressed air supply is dis-
connected when replacing the saw blade
First open the front cover
(see Fig. E).
Use the included socket head wrench
loosen the socket head screws on the saw blade
holder (see Fig. F) and remove the saw blade.
Then insert the new saw blade
blade holder and tighten the socket head screws
again.
Ensure the saw blade
the saw blade holder and cannot be pulled out.
Then close the cover

Cleaning and storage

To ensure a long life and trouble-free operation, it's
important to observe the following instructions.
Always disconnect the tool from the compressed
air supply before cleaning.
Clean your tool with a dry, soft cloth or lightly
blow it out with compressed air. Never use
caustic cleaners.

Lubricating the air saw

Note: Regular lubrication is required
to ensure the longest possible life to
air tools.
Turn the tool over so the air connection is facing
up and add a few drops of air tool oil or SAE
10–20 engine oil to the tool's air connection.
Activate the trigger
perse better.
Hold a rag or absorbent paper towel in front
of the exhaust opening and run the tool on idle
for a few seconds.
110140_par_Druckluft-Saege PDKS 6.0 A1_content_ES_IT_PT.indd 41
After initial use / Cleaning and storage / Maintenance
if dull, warped
1
!
1
with a screwdriver
7
to
2
into the saw
1
is correctly seated in
1
with the screwdriver.
7
to allow the oil to dis-
4
ATTENTION! Remove the compressed
air connection before performing main-
tenance!
Excess oil will be blown out.
Keep persons or objects away from the discharge.

Storing the air saw

Store the air tool in a dry location, protected from
the weather and out of the reach of children.
Be sure moisture does not enter the inside of
the air tool.

Maintenance

The device should be regularly maintained (after
about 1–2 uses).
Always wear suitable work gloves.
Maintenance must be performed by trained per-
sons. Adhering to these maintenance instructions
will ensure a long life and proper operation of
this quality product.
Disconnect equipment from the compressed air
source when performing maintenance and care.
Check the condition of wear and tear items
and accessories with every maintenance.
Note: Daily cleaning and regular lubrication
are absolutely required for smooth operation.
Only use special tool oil with a high viscosity
(thin) for this purpose. Oil for compressed air
equipment or motor oil SAE10–20 are suitable.
ATTENTION! Do not use any other (especially
high viscosity) lubricant. Otherwise there will
be a danger of functional disturbance or per-
manent damage.
Operate the device with clean air. Corrosion
residue, dust and dirt from the supply line impact
performance and result in technical problems.
Such contamination can be countered using a
service unit with filter, reducer valve and oiler.
If necessary, clean your device with a damp cloth.
Do not use chemical cleaners containing aggres-
sive substances such as petrol, thinner, etc., as
these may damage the plastic.
GB/MT 41
02.07.15 11:20