Operation - Hupfer ITW Manual De Instrucciones

Operation

Operation
Keeping warm
The warming phase will be automatically activated on completion of the regeneration process, if a warming
phase is provided in the program menu.
The warming phase can be stopped by pressing the on/off key (7) and by another brief pressing of the
on/off key (7) it can be restarted.
The program will be interrupted by a long pressing of the on/off key (7).
Pause/Interrupt
For aborting the regeneration process briefly press the on/off key (7) (PAUSE), then press the on/off key af-
ter a short pause for 2 seconds (REGENERATION ABORTED) and a third time to briefly confirm once
again.
To pause the regeneration process briefly press the on/off key(7). If the interruption takes longer than five
minutes, the program will be interrupted.
5.3 Operation
ATTENTION
ATTENTION
Loading
NOTE
Proceed as follows to load the induction trolley:
§
Lock the induction trolley with the total locks to prevent from rolling back.
§
Insert EN trays or GN trays in the sideways guides.
§
Lock the doors.
Switching on
NOTE
§
Connect the induction trolleyInduction trolley to the mains. The mains plug is on the left side of the
appliance. Alternatively, connect the device with the special plug to the external generator.
If the device is connected to the mains, the control will start with the initialization. The display shows three
successive information images and all four LEDs light up. The induction trolley is ready for operation.
91249668_A2
Appliance damages
Heavily loaded induction trolleys can roll and tip over during the traction oper-
ation. Do not exceed the maximum traction speed of 2.5 mph (4 km/h). The
maximum speed applies for flat and dry concrete and a path width of 2.5 m.
You can tighten up to three induction trolleys in a row. Reduce the traction
speed accordingly when changing a parameter.
Damage to appliances
Mobile induction trolleys may not be touched at the spool carriers or moved
manually. The spool carriers can break easily.
For moving the devices always hold the push bars.
Suitable crockery
Place only appropriate induction crockery released by
tioned meals on the intended markings of the trays. During the operation there
should be no GN containers, cutlery or any other metal objects in the induc-
tion trolleys.
Operation with circulation cooling system
Only switch on devices with a circulation cooling system when the doors are
closed.
Section 5
Page 21
®
HUPFER with por-
Induction trolley
ITW