Troubleshooting; All Functions - American Standard Advanced Clean 100 Combo Manual Del Usuario

Troubleshooting

Failures can be easily corrected in some cases. Please check the following items.

All Functions

Symptom
All functions
are inoperable
(power indicator
is not on).
Corresponding
operations are
not performed
when switches
on the remote
control are
pressed (power
indicator is on).
Corresponding
operations are
not performed
when switches
on the remote
control are
pressed (power
indicator is on).
*: When the remote control is installed on the wall opposite the receiver, the batteries may fully discharge before the battery LED
starts flashing.
Cause
Electricity is not supplied to power
outlet.
The power is turned off (power
indicator is not on).
The power plug is not connected to
the power outlet.
A short circuit has occurred. The
indicator LED is on.
Voltage other than 120V is being
used.
Batteries in the remote control
have completely discharged.
*
(Battery LED is on )
Batteries are installed in the remote
control in the incorrect orientation
of polarity.
Remote control transmitter or
receiver is dirty or wet.
A fluorescent light with inverter
ballast is in use.
Remote control receiver is exposed
to direct sunlight.
The "OFF" text string appears on
the remote control LCD.
Solution
Check for a power failure, tripper
breaker, etc.
Press the 【POWER】 button and
make sure the power indicator on
the flush button turns on.
Completely connect the power plug
to the outlet.
Wait about 10 seconds before
reconnecting the power plug.
Disconnect the power plug and
have the SpaLet® serviced.
Disconnect the power plug and
have the SpaLet serviced
Replace with new batteries.
Insert the batteries in the correct
orientation.
Remove the dirt or water.
Turn off the light and try again.
If the SpaLet then operates
normally, there is no malfunction in
the product.
Take the necessary action to prevent
exposure to direct sunlight.
Press the 【POWER】 button to turn
on the remote control.
Page
ー
7
7
ー
ー
44
44
ー
ー
ー
ー
46 - EN