American Standard Advanced Clean 100 Combo Manual Del Usuario página 42

Cleaning and Maintenance
Extending Nozzles/Opening Shutters [Ejecting Nozzles]
The nozzle can be ejected for cleaning or to replace tips.
The nozzle shutter can be opened and removed, and the deodorizing filter can also be removed.
1 Turn off both 【Auto Clean】 and 【Auto
Seat Open】 ( ☞ Page 17 and 18).
* If these functions are not turned off, water could
flow or the SpaLet ®
when the SpaLet detects the presence of a person.
* Do not forget to turn the functions back on after you
have finished cleaning.
2 Open the SpaLet seat lid and the SpaLet seat.
3 Press the 【Nozzle Cleansing】 button.
* When pressing the Nozzle cleansing button (first time), the rear
nozzle wand extends back and forth several times while water
sprays onto it cleaning it, then the rear nozzle wand retracts and
the front nozzle wand extends several times while water sprays
onto it cleaning it. Then the front wand retracts and the rear wand
extends and will stay extended for approximately 5 minutes or
until a function button is pressed. (Note: at this time the rear
nozzle tip can be removed from the wand and further be cleaned
manually with a soft cloth, then placed back into the wand before
5 minutes are up. (Ref Removing Nozzle TIPs Below)
4 Press the 【Nozzle Cleansing】 button.
* When pressing the Nozzle Cleansing button a second time, the rear nozzle wand retracts and the front nozzle
wand extends for approximately 5 minutes or until a function button is pressed. Note: at this time the front nozzle
tip can be removed from the wand and further be cleaned manually with a soft cloth, then placed back into the
wand before 5 minutes are up. (Ref Removing Nozzle TIPs Below).
5 Press the 【Nozzle Cleansing】 button.
* Pressing the Nozzle Cleansing button a third time retracts the front nozzle wand and opens the shutter
in a way that enables it to be removed and or clean the deodorizing filter.
6 Press the 【STOP】 button to return the nozzle shutter to the original position.
* If the nozzle catches, perform the procedure to eject the nozzle again.
REMOVING the Nozzle Shutter:
To open the shutter press the Nozzle Cleansing button, then go through Steps 3, 4 and 5 completely. This will enable the
Open Shutter for 5 minutes. Pressing the Nozzle Cleansing button 3 times without following Steps 3, 4 and 5 completely will
not enable the Open Shutter.
39 - EN
seat could close unexpectedly
【 Auto Clean 】 【 Auto Seat Open 】
【 Nozzle Cleansing 】