Flushing The Spalet ® Manually - American Standard Advanced Clean 100 Combo Manual Del Usuario

Useful Information
Flushing the SpaLet
The SpaLet bowl cannot be flushed using the remote control during a power outage.
Use the following procedure to flush the SpaLet.
1 Remove the side cover on the left side
when facing the SpaLet body ( ☞ Page 42).
* The red SpaLet flushing lever used during power
outages should now be visible.
Side cover
2 Turn the red flushing lever toward you and
hold it in this position for approximately 5
seconds.
* Water will flow around the SpaLet bowl to flush
waste to the bottom of the SpaLet bowl.
Flushing the SpaLet in the Event of a Suspended Water Supply
Pour a bucket of 5 to 6 liters (1.4 to 1.6 gallons) of water into the SpaLet while
being careful not to spray water to flush waste in the SpaLet.
Then pour another 3 to 4 liters (0.8 to 1 gallon) of water into the SpaLet to fill the
SpaLet bowl to normal levels.
* Pour more water a little faster if the waste does not flush properly.
* Perform the same procedure for a partial flush.
[CAUTION]
● Be careful not to spill water onto the floor when carrying water in a bucket or
when pouring water into the SpaLet.
● Do not allow water to splash onto outlets.
®
Manually During Power Outages
Red flushing lever
Inside the
SpaLet
bowl
3 Once the waste has reached the bottom of
the SpaLet bowl, turn the red flushing lever
back to the rear and hold it in this position
for approximately 5 seconds.
* Water will flow to flush the waste out of the bottom
of the SpaLet bowl.
4 Once the waste has been flushed, turn the red
flushing lever toward you again and hold it in
this position for approximately 5 seconds.
Water will flow around the SpaLet bowl to fill the
bottom of the SpaLet bowl with water.
Once the SpaLet bowl is filled with water, release the lever.
The lever will return to its original position
automatically and the flow of water will stop.
5 Reattach the side cover ( ☞ Page 42).
Inside the
SpaLet
bowl
Inside the
SpaLet
bowl
28 - EN