Useful Information - American Standard Advanced Clean 100 Combo Manual Del Usuario

Useful Information

®
The SpaLet Seat Temperature
is Adjusted to Set Levels.
The temperature of the SpaLet seat is maintained
at constant temperatures in accordance with the
temperature set with the switch.
Seat temp.
Off (room temperature) and Low (approx.
28ºC/82.4ºF) to High (approx. 36ºC/96.8ºF)
Nozzle Spray in Winter.
The nozzle spray may weaken or take longer than
usual to discharge during winter or other times when
the water temperature is significantly low.
The Seat Sensor Prevents
Incorrect Operation.
This SpaLet is equipped with a seat sensor to prevent
the nozzle from spraying if switches are pressed
when no one is sitting on the SpaLet seat.
* The rear washing, rear washing - mild, front
washing, and dryer functions do not operate if no
one is sitting on the SpaLet seat.
* The seat sensor may not function correctly if covers
are installed to the SpaLet seat or SpaLet lid.
* Rear washing or similar functions may not operate
during a brownout while using the SpaLet. In such
cases, stand up from the SpaLet and wait 1 to 2
seconds before sitting back down.
The SpaLet Seat and SpaLet
Lid Close Slowly.
To reduce potential impact when the SpaLet seat and
SpaLet lid close unexpectedly, the
SpaLet is equipped with a damping
mechanism to close the SpaLet seat
and lid slowly.
This damping mechanism does not
function when the power is turned off.
* Note that closing the SpaLet seat and lid forcefully
may cause damage.
25 - EN
The SpaLet is Equipped with a
Low Battery Indicator.
The battery LED on the remote
control flashes when the
batteries are low. Replace with
new batteries as soon as
possible. ( ☞ Page 44)
* Pressing a remote control switch while the battery
LED is flashing sometimes causes signals not to
reach the Spalet body, which results in no operation.
Bleed Air from the Water Pipes
Before Initial Use.
Make sure to bleed air from the water pipes before
using the SpaLet for the first time or after the water
had been drained to prevent freezing.
When siting on the SpaLet seat, water discharges from
a point near the nozzle tip for approx. 30 seconds.