Assembly - ProTeam ProGuard 16 MD El Manual Del Propietario

DRUM/CADDY
If any parts are missing or damaged
contact ProTeam Customer Service.
DO NOT assemble until you have all the
parts.
1. Remove left and right caddies from
drum.
2. Install cap nut on one side of shaft
rod. Tap gently with rubber mallet
or hammer until fully seated. Slide
open end of shaft through the wheel
(smooth side of wheel facing outward).
3. Place wheel/shaft assembly through
caddy left and on through the caddy
right, as shown.
4. Then place the remaining wheel onto
the caddy assembly (smooth side of
wheel facing outward), and install
second cap nut.
5. Invert drum to install caddy. Place the
caddy assembly onto the drum, as
shown. Be sure that wheels spin freely,
and DO NOT contact the caddies.
6. Once the caddies are aligned on
the drum, gently tap each end of
each caddy until firmly seated. It
is recommended to tap the center
portion of the front caddies, as shown.
7. Using a rubber mallet or hammer,
gently tap the wheel caps onto each
wheel until the wheel caps are firmly
seated onto each wheel. This is
required on both sides.
ProTeam

ASSEMBLY

NOTE: Smooth side of
the wheel to the outside.
Shaft
Rod
CADDY
ASSEMBLY
Caddy Left
Caddy
Right
1/16" Clearance
TAP
Cap
Nut
Wheel
Cap
Nut
Caddy
Wheel
TAP
Wheel Cap
Mallet
5