Installing Tool Holder; Insert Hose - ProTeam ProGuard 16 MD El Manual Del Propietario

INSTALLING TOOL HOLDER

1. Install tool holder as shown with exten-
sion wand holders (not included on all
models) facing unit.
Tote Snaps
WET/DRY VACUUM ASSEMBLY
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum
ProTeam
ASSEMBLY
Tote
Straps (4)
Handle
Extension
Wand
Storage
Locations
Drum
Latch
Drum
Flange
(Continued)
2. As an alternative storage solution, the
tool holder may hang on a wall. Two
wall mounting hooks (not included)
must be secured to the wall as shown
(sold separately).

Insert Hose

Insert the push button end of the hose
into the inlet of the Vacuum. The hose
should snap into place.
To remove the hose from the Vacuum,
press the release button in the hose
assembly and pull the hose out of the
Vacuum inlet, as shown.
Press the curved metal extension wand
into the coupling ring of the hose end.
Join the two metal extension wands,
aligning the button and hole so they snap
together.
Attach the accessories, aligning the
button and hole so they snap together.
Coupling
Ring
Metal
Extension
Wand
(Curved)
Metal
Extension
Wand
(Straight)
Accessory
Grommet
Wall Mount
Hook
(Not Included)
Wall
Press Release
and Button
Pul l
Wet/Dry Vac &
Hose Assembly
7