Filter Assembly/Replacement - ProTeam ProGuard LI 3 Manual Del Propietário

FILTER ASSEMBLY/REPLACEMENT

WARNING - To reduce the risk of injury from accidental starting, remove
!
battery before removing the filter .
1 . Grasp the drum latches on both the right and left side of the power head . Slowly
pull the drum latches out and up from the drum . Lift the power head off the
drum . Place the lid assembly of the Vacuum upside down (Figure B) .
2 . Carefully slide the Qwik Lock™ filter over the filter cage and press down on the
outside edge of the filter until the rubber gasket on the bottom of the filter
seats securely around the base of the filter cage and against the lid (Figure C) .
3 . Align the small center hole in the top of the filter over the Qwik Lock™ stud on
the filter cage . Press firmly on top of the filter near the stud to allow the filter
to snap over the ball on the end of the stud . The filter is now attached .
NOTE: Failure to properly seat the bottom gasket could result in debris bypassing
the filter .
4 . To assemble the power head to the drum, position power head over drum, with
drum latches lined up with recess in drum . (The power head will only fit on the
drum one way .)
5 . Position bottom of the latch in drum recess . Push top of latch towards power
head to lock .
6 . Your Vacuum is now ready to use . Read the instructions on the following pages
to operate your Vacuum safely .
Power
Head
Latch (one
on each
side)
PULL LATCH OUT
FROM THE TOP
AND UP FROM
THE BOTTOM
Figure B
ProTeam
Filter
Qwik Lock™ Stud
Filter Cage
Figure C
Power
Head
7