Assembly - ProTeam ProGuard 15 Manual Del Propietário

3. Place the squeegee pivot plate inside
the mounting bracket with the pedal of
the squeegee pivot plate at the back of
the cart (as shown in Figure C).
4. Place the 3/8" bolt through pivot
plate and adjust the bracket front
to back (if needed) so pedal latches
properly (Figure C). Remove the 3/8"
bolt and squeegee pivot plate and
tighten the two 5/8" bolts holding
the squeegee mounting bracket in its
proper position. Repeat Steps 3 and 4
if needed for proper pedal alignment.
Wheels Removed for Clarity
Release
Pedal
5. With the squeegee pivot plate
removed, hook the spring into the
thumb screw (provided in base).
6. Secure the wire tie in a loop and hook
it to the spring as shown (Figure D).
Thumb Screw
Spring
Wire Tie
Figure D
4

ASSEMBLY

Squeegee
Pivot Plate
Mounting
Bracket
Pedal Latch
7. Place the squeegee pivot plate inside
the mounting bracket with the pedal of
the squeegee pivot plate at the back of
the cart (as shown in Figure E).
Figure E
8. Feed the wire tie and spring though
the opening in the pivot plate.
9. Using the wire tie, stretch the spring
and place the pin through the spring
into the slots as shown (Figure F).
Remove the wire tie after installation
of pin.
Figure F
ProTeam Front Mount Squeegee
Mounting
Bracket
Squeegee
Pivot Plate
Pin