Filters; Removal And Installation Of The Qwik Lock™ Filter - ProTeam ProGuard 16 MD El Manual Del Propietario

FILTER REMOVAL AND
INSTALLATION
Removal and Installation
of the Qwik Lock™ Filter
Filter Removal:
1. Hold the filter tabs of the Qwik Lock
Wet Filter, or fine Dust Filter in each
hand.
2. With one thumb on the Qwik Lock
stud, which protrudes through the
integrated filter plate, lift up on the
filter tabs while pushing down on the
stud.
3. This action will cause the filter to
release from the filter cage. Slide filter
off cage.
Filter Installation:
1. Carefully slide the Qwik Lock filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the
filter seats securely around the base of
the filter cage and against the lid.
2. Align the small center hole in the top
of the filter over the Qwik Lock stud on
the filter cage. Press firmly on top of
the filter near the stud to allow the filter
to snap over the ball on the end of the
stud. The filter is now attached.
NOTE: Failure to properly seat the
bottom gasket could result in debris
bypassing the filter.
WARNING: DO NOT operate
!
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
8

FILTERS

www.pro-team.com or contact
ProTeam's Customer Service Department
Quick Lock Wet Fine Dust Cartridge Filter - 107175
Quick Lock HEPA Media Filter - 107176
To Reorder Filters: Go to
at 866.888.2168
Quick Lock Wet Filter - 107177
ProTeam