NIOSH - CAUTIONS AND LIMITATIONS
POWERED AIR
A.
Not for use in atmospheres containing
less than 19.5 percent oxygen.
B.
Not for use in atmospheres immediately
dangerous to life or health.
C.
Do not exceed maximum use
concentrations established by regulatory
standards.
F.
Do not use powered air-purifying
respirators if airflow is less than 4CFM
(115lpm) for tight fitting face pieces
or 6CFM (170lpm) for hoods and/or
helmets.
H.
Follow established cartridge and canister
change schedules or observe ESLI to
ensure that cartridge and canisters are
replaced before breakthrough occurs.
I.
Contains electrical parts that may cause
an ignition in flammable or explosive
atmospheres.
J.
Failure to properly use and maintain this
product could result in injury or death.
L.
Follow the manufacturer's User's
Instructions for changing cartridges,
canister and/or filters.
M.
All approved respirators shall be selected,
fitted, used and maintained in accordance
with MSHA, OSHA, and other applicable
regulations.
N.
Never substitute, modify, add or omit
parts. Use only exact replacement parts
in the configuration as specified by the
manufacturer.
O.
Refer to user's instructions, and/or
maintenance manuals for information on
use and maintenance of these respirators.
P.
NIOSH does not evaluate respirators for
use as surgical masks.
INSERT APPROVAL LABEL HERE
SUPPLIED AIR
A.
Not for use in atmospheres containing
less than 19.5 percent oxygen.
B.
Not for use in atmospheres immediately
dangerous to life or health.
C.
Do not exceed maximum use
concentrations established by regulatory
standards.
D.
Air-line respirators can be used only
when the respirators are supplied with
respirable air meeting the requirements of
CGA G-7.1 Grade D or higher quality.
E.
Use only the pressure ranges and
hose lengths specified in the user's
instructions.
J.
Failure to properly use and maintain this
product could result in injury or death.
L.
Follow the manufacturer's User's
Instructions for changing cartridges,
canister and/or filters.
M.
All approved respirators shall be selected,
fitted, used and maintained in accordance
with MSHA, OSHA, and other applicable
regulations.
N.
Never substitute, modify, add or omit
parts. Use only exact replacement parts
in the configuration as specified by the
manufacturer.
O.
Refer to user's instructions, and/or
maintenance manuals for information on
use and maintenance of these respirators.
S.
Special or critical user's instructions and/
or specific limitations apply. Refer to
user's Instruction page 8 before donning.
7