RPB Z-Link Manual De Instrucciones página 25

REPLACING THE WELDING VISOR FLIP-UP MECHANISM
FIGURE 171
The flip-up mechanisms and springs can
be replaced if needed. Using a small screw
driver, remove the three screws that hold in
the mechanism being careful to not strip the
plastic they are threaded into.
FIGURE 17.3
Carefully align the replacement spring and
the flip-up mechanism onto the pegs in the
Welding Visor. Insert and screw in the 3
replacement screws to attach the spring and
mechanism without over tightening.
FIGURE 17.2
Position the spring onto the new flip up
mechanism and secure it with the screw
provided.
INSTALL/REPLACE WELDING CAPE
FIGURE 18.1
When welding, be sure to install a approved
RPB welding cape for adequate protection
®
from sparks, debris, and light flashes. Follow
the cape installation instructions on page 16.
25