RPB Z-Link Manual De Instrucciones página 19

FACE SEAL/CAPE INSTALLATION/REPLACEMENT
FIGURE 10.1
To install the cape or face seal, start by
attaching the cape clips on the sides of the
cape. Make sure the clip goes over the notch
on the helmet and the clip edge goes into the
track around the edge of the helmet.
When using a face seal, make sure the elastic
edge is under the users chin at the front and
is in contact all of the way around the neck
and back of the head.
FIGURE 10.2
Then press the rubber trim on the cape or
face seal into the track that goes around the
underside of the helmet, making sure the
cape/face seal is completely attached all of
the way around.
FIGURE 10.3
When using a cape, adjust the elastic cord in
the inner collar to ensure a snug fit around the
user's neck and pull the fabric down all of the
way around over the shoulders so that it isn't
bunched up.
FIGURE 10.4
19