RPB Z-Link Manual De Instrucciones página 23

INSTALL/REMOVE WELDING VISOR
FIGURE 15.1
To install the Z-LINK Welding Visor, remove
®
the pivot pin caps on the Z-LINK
FIGURE 15.3
Line up the Welding Visor connection sockets
with the Pivot Pins on the Z-LINK
them into the Z-LINK until they snap in
®
securely. This can be done while wearing the
Z-LINK .
®
FIGURE 15.2
Insert the caps into the holding sockets on the
Head Harness Bracket so they don't get lost
®.
while using the Welding Visor.
FIGURE 15.4
The Welding Visor can be rotated up
and insert independently of the Visor or together with
®
the Visor.
23