Warnings - RPB Z-Link Manual De Instrucciones

!WARNINGS!

1. Ensure that the helmet is correctly
assembled in the configuration that
suits your application. When used for
welding make sure that it completely
blocks any accidental light. In the front,
light may enter the helmet only through
the viewing area of the auto-darkening
welding filter.
2. Check the prescribed shade level for your
welding application and adjust your auto-
darkening filter accordingly (see the table
with recommended shade levels Pg. 25).
3. Never place the helmet or the auto-
darkening welding filter on hot surfaces.
4. Scratched or damaged safety lenses
should be regularly replaced with
genuine RPB replacement parts. Before
®
using the new safety lens, make sure to
remove any additional protection film
from both sides.
5. Use the RPB Z-LINK
®
temperature range of 14°F to 140°F
(-10°C to +60°C).
6. Do not expose the auto-darkening
welding filter to liquids and protect it from
dirt.
7. Improper use of this respirator or
use not in accordance with this User
Instruction Manual may cause injury or
death. Improper use may also cause life
threatening delayed lung, skin and eye
disease. The RPB
is manufactured to protect the operator's
face and head against sparks and
hazardous ultraviolet and infrared rays
emitted during the welding process. It is
not intended to be used as a protection
against impact, flying particles, molten
metals, corrosive liquids or hazardous
only within the
®
Z-LINK Respirator
® ®
gases.
8. Materials which may come into
contact with the wearer's skin could
cause allergic reactions to susceptible
individuals.
9. Respirator worn over standard spectacles
may transmit impact, thus create a
hazard to the wearer.
10. Be certain your employer has determined
that the breathing air source provides
at least a Grade D breathable air as
specified in the compressed gas
association commodity specification
G-7.1. The respirator must be supplied
with clean breathable air at all times.
A carbon monoxide monitor must be
used at all times. Contact your RPB
distributor for a GX4 Gas Monitor. Do not
connect the respirator's air supply hose to
nitrogen, toxic gases, inert gases or other
unbreathable non-Grade D air sources.
Check the air source before using the
respirator. This apparatus is not designed
for use with mobile air supply systems i.e.
cylinders. Failure to connect the supply
hose to the proper air source could result
in serious injury or death.
11. The RPB Z-LINK
®
provide hearing protection. Earplugs or
earmuffs must be properly fitted when
exposed to noise levels that exceed the
OSHA permissible exposure levels.
12. Do not use this respirator until you
have been trained in the respirator's
use, maintenance and limitations by a
qualified individual (appointed by your
employer) who has extensive knowledge
on the RPB Z-LINK
®
training must be in accordance with the
®
Respirator does not
®
Respirator. All
®
5