Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Various Utility Stitches
Basting
O Stitch pattern:
Thread tension dial:
(_) P: Embroidery foot
!9
t to 3
J
!
19
1_"4
P
3.5
Attaching the Embroidery Foot
[] Raise the needle
[j_ Remove the foot holder by loosening the thumb
screw.
[] Attach the Embroidery foot on the presser bar
putting the pin on the needle clamp_ Tighten the
thumb screw firmly with a large screwdriver,.
0 Foot holder
Q Thumb screw
_) Pin
Needle clamp
f
[]
J
d
°Starting to sew
[_ Lower the feed dogs by switching the drop feed lever to
the
right,,
(See page 24)
[] Set the thread tension dial between 1 and 3o
[_ Put some fabric under the foot and press Up/down
needEe button twice to bring the needle thread down
through the hole in the foot,. Pull the fabric and thread
to the rear. Lower the presser foot°
[] While pressing clown the foot control, gently pull and
guide the fabric.
[] When the machine is stopped after I stitch sewing,
pull the threads and fabric to the near side and cut the
threads.
[] Repeat steps [] to [] to sew. Afrer finishing sewing,
pull the threads and fabric to the rear sider
'*,_,
J
* After sewing, reset the thread tension dial at "AUTO"
and raise the feed dogs, slide the drop feed lever to
the left.
52
Tabla de contenido
