Replacing The Battery - Anselmo Cola AFRODITE Manual De Instalación, Uso Y Mantenimiento

MENU 11 – ECO mode
Selecting ON in ECO mode limits stove operation to modulation, i.e. at minimum power. The display shows the
message ECO MOD.
4.2.5

Replacing the battery

The remote control is powered by tree batteries located in the back of the device. For insertion and possible replacement, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the AAA 1.5 V batteries, respecting the
polarity;
- Close the remote control
- Keep the remote control away from direct heat sources and water.
- The battery of the remote control must be replaced and disposed of in a safe way,
respecting the local regulations;
4.3 Use via control panel
To access the panel, remove the protection profile in the bottom of the stove .
Press button P3 on the control panel for a few seconds to turn the stove on and off. Use buttons P1 and P2 to set
the maximum power, indicated by the LED of button P2. Then the medium power equal to power 3, indicated by
lighting up of the LED of buttons P1 and P2, and lastly the minimum power, indicated by the LED of button P1.
It is not possible to set the temperature, the intermediate operating powers or access the various menus with the
emergency panel.
4.4 Hot air outlet flow adjustment
The SPRINT stove has a centrifugal fan for heat exchange with the combustion chamber, allowing the flow of hot air
to be conveyed frontally to the stove and/or at the top in ducting as described in par. 1.4; the hot air flow direction is
controlled manually by an internal valve with a lever and rod with knob.
The hot air flow depends on the choice of outlets and stove output; level 5 gives the maximum fan speed with
maximum flow of hot air.
The stove can convey the hot air flows entirely or partially to the front upper grille or the top grille and in the
connection of the ducting system by means of a valve controlled manually with a lever and rod; the rod, provided
with a knob, has 4 reference notches for selecting the hot air flow direction as shown in the figure.
Control rod in top position 1st reference
HOT AIR FLOW in
Hot air flow direction control VALVE
frontal direction
Cover
Control rod in bottom position
4th reference HOT AIR FLOW in
upper direction and in
45
ducting
AFRODITE