Section 3: User Guide: General Operating Information A. User Dial Control; Filling The Hopper - Pleasant Hearth PH35PS Manual Del Usuario

3
User Guide: General Operating Information
A. User Dial Control
The appliance has one dial control located on the side of
the unit used for daily operation. There are four primary
settings on this dial.
1) Off : When the dial indicator is in the off position
the unit will go into a shut down and remain off
until the dial is turned to one of the other three
settings. The LED will flash green once per
second when in the off position.
2) MIN : When the dial indicator is directed to the
MIN setting (small flame on the label) the unit
will burn on low until the hopper runs out of
pellets or the dial control is turned to a different
setting. When in this setting the LED will be
amber in color and continuously on. When
burning in this mode, the unit should be turned
off at least once daily for cleaning. If lower
quality fuels are used, additional daily shut
downs may be required for cleaning.
3: MAX : Similar to the MIN mode, the unit will
run continuously at the high burn rate until the
unit has run out of fuel or the dial is turned to a
different setting. To operate in this mode, turn the
dial clockwise until it stops. The dial
indicator will point to the large flame. When in
this setting the LED will be amber in color and
continuously on. Follow the daily cleaning
recommendations when operating in this mode. If
lower quality fuels are used, additional daily shut
downs may be required for cleaning.
4: AUTO : To burn in the Automatic mode, turn
the dial control clockwise to the desired comfort
level. When operating in the automatic mode, the
unit changes the burn setting based on the
difference between the room temperature and the
desired set point. In other words, the unit will
burn on High if the difference between the
desired and room temperature is greater than 8
degrees Fahrenheit. As the room heats up and
the gap closes, the unit will automatically reduce
the burn rate. When the room temperature is close
to the set point the light will stop flashing stay solid
green. At this time the stove will be burning on the
lowest burn rate. When the desired temperature is
achieved the unit will shut down. As the room cools,
the unit will restart automatically. When burning
in this mode the LED will be blinking green. The
number of green flashes corresponds to the current
burn rate.
[email protected]
B. Filling the Hopper
Slowly open the hopper lid by lifting the handle. The
medium and large units have a locking latch that will
engage when the hopper lid is fully opened. The hopper
lid for the cabinet will open past ninety degrees and
stay open automatically. Fill the hopper with fuel. FOR
USE WITH ONLY WOOD PELLET FUEL. Slowly close
the hopper lid. See figure below for releasing the latch.
NOTE: The unit will not feed with the hopper lid open. If
left open, the fire will go out.
7077-171I • December 08, 2016
Push Bottom of Latch
Inward to Release
7