Locating Your Appliance & Chimney; Inspect Appliance & Components; Tools & Supplies Needed - Pleasant Hearth PH35PS Manual Del Usuario

6
Getting Started
D. Locating Your Appliance & Chimney
Location of the appliance and chimney will affect
performance.
• Install through the warm airspace enclosed by the building
envelope. This helps to produce more draft, especially
during lighting and die-down of the fire.
• Penetrate the highest part of the roof. This minimizes the
affects of wind loading.
• Locate termination cap away from trees, adjacent
structures, uneven roof lines and other obstructions.
• Minimize the use of chimney offsets.
• Consider the appliance location relative to floor and ceiling
and attic joists.
• Take into consideration the termination requirements.
Location NOT recommended:
• Not the highest point of the roof
• Wind loading possible
Windward
Recommended:
Outside Air Intake
on windward side
E. Inspect Appliance & Components
• Remove appliance and components from packaging
and inspect for damage.
• Report to your dealer any parts damaged in shipment.
• Read all the instructions before starting the instal-
lation. Follow these instructions carefully during
the installation to ensure maximum safety and
benefit.
[email protected]
Recommended Location:
Recommended Location: • Above peak
• Inside heated space
• Above peak
Marginal Location:
• Below peak
Recommended:
• Insulated exterior chase
in cooler climates
Multi-level Roofs
7077-171I • December 08, 2016
F. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing masonry fireplace:
Reciprocating Saw
Channel Locks
Hammer
Phillips Screwdriver
Tape Measure
Plumb Line
Level
Framing Material
Non-combustible Sealant
Material
Marginal Location:
• Wind loading possible
WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
Gloves
Safety Glasses
Framing Square
Electric Drill & Bits (1/4")
1/4" Self-Tapping Screws
May also need:
Vent Support Straps
Venting Paint
Location NOT recommended:
• Too close to tree
• Below adjacent structure
• Lower roof line
• Avoid outside wall
Leeward
NOT recommended:
Outside Air Intake
on leeward side
23