Calibrating The Test Leads ("Cal" Mode) - Amprobe MultiTest 2000 Manual De Usuario

AMPROBE

6.1.1. Calibrating the test leads ("CAL" Mode)

1. Connect the black and blue test leads to B1 and B4 input terminals
respectively.
Connection of instrument terminals during calibration procedure.
2. If the test leads supplied with the instrument are not long enough for the
measurement you can extend the blue cable.
3. Short-circuit the measuring cable ends making sure that the conductive parts of the
alligator clips make good contact with each other (see previous picture).
4. Press the F2 key. The instrument performs the calibration.
ν
ATTENTION:
Never disconnect
"MEASURING" is displayed.
LOWΩ
B1 B4
B2 B3
the test leads when
05.06.01
MULTITEST2000
the message